Fluorescent technology has been used for many years, since the beginning of the 40 years, being one of the most widespread lighting systems in the world. During the years 90 began the industrialization of led lighting devices as we know them today, starting to spread their marketing for all homes, businesses etc ...
Currently, the use of LED devices has been extended so much that we can already have LED tubes to replace the fluorescent, these being a more than reasonable price and within reach of everyone.
Advantages of the led tube versus the fluorescent
With the change of the fluorescent tube to the LED get lower power consumption, about 70% less, a superior life of approximately 50.000 hours and greater ease of maintenance, since the LED tubes need neither primer nor ballasts for operation, besides not alter our environment. The main differences between the two are as follows:
Comparison Chart: Front Tube Led Fluorescent Tube
For all these reasons, changing the fluorescent tube LED tube is justified, so it is advisable to get lower electricity consumption and see thus reduced our bills. In Deniluz we'll help you solve all your questions and explain the most effective way to make these changes.
Contact Deniluz
| Dénia-Ondara km road. 0'5 | |
| deniluz.com | |
| pages | |
| deniluz@deniluz.com | |
| Home, Engineering, Leisure | |
Trade Closed | |
Change the fluorescent tubes for led tubes in two lamps, one with three tubes and the other with two, remove the components, ballasts and starters,
Make the connections, connect one pin of the two to a positive phase and at the other end of the tube one of the pions to a negative phase,
The two lamps worked immediately, producing good lighting. my question is that the tubes started to stop turning on, the life time of led tubes is very short compared to fluorescent tubes. I wait for the answer
At the moment the LED lighting is very pobre..Basta to see the streets lit with LED lamps, whose visibility has nothing to do with the sodium or hmi, or 99 percent of shops lit with LED ..: Nothing to do with the espectaculadidad halide ..Salgan the street and compruebenlo..eso si..menudo loby was set up with the whole issue of led..Somos many who have tried and disposal of them ..
Hi I need to know because flashing LED sign outside tubes placed in seven tubes 120 want to think that all are the transformers but not block me, I have placed 7 transformers of 12v 2,2A may be very potetes output in watts w
Hi I have connected 7 fluorescent tube led 120 and consumption of 18w me were good but time took a few days k all start to flash after forming to place are 12v 2,2A be possible to be very strong, can connect 3 tubes to the same trasformador donot
My main question is what type of installation you have done and what type of tubes are. Currently in the market there are different LED tubes; would normally not in need transformer, as is often bridged. Still, depending on whether they are one-sided, or two, or even if an LED primer is required, all installations are different.
If you have any doubts, come to the store and we will explain you from here, and with physical examples as they should be.
friend flicker speaking, is nothing more than the effect of harmonics that can be seen in this way, it is common to happen in facilities with high computer equipment and fixtures of this type
With the advantages that it has, they should put them within reach of all pockets.
That are cheaper, so people who can not pay nearly electricity
of your home you can buy them.